Products

Clamp plate used as part of the #7 Spring Jump and #8 Spring Jump assembly mountings. Old Part No.003-302107-002

Clamp plate used as part of the #7 Spring Jump and #8 Spring Jump assembly mountings. Old Part No.003-302107-002

Metal spacer used to space out sprockets by 30mm. Designed to fit onto a 50mm shaft. Alternate Part No.117-411

24 TOOTH SIMPLEX SPROCKET, 5/8" PITCH, 25.4 (1") ID BORE

Tapered Roller Bearing suits AP81 and AP91 wheel assemblies. Used on the 10-stud KHitch hub assembly. There are two bearings utilized per hub.

CROWN NUT, suits AP81 and AP91 machines. CROWN NUT ONLY

Machined hub part to suit 10 stud axle assembly on AP81, AP91 and AP92 machines. This hub is used in conjunction with these parts:  1 x HUB CAP    ...

Sweeps are designed for the #9 and #8 shank assemblies and can fit to any shank with 22mm 1/2" holes. Sweeps increase the shanks effect on the grou...

This bearing spacer is utilised on the #9 Hydraulic Swing arm and has been designed to fit through a 40mm bearing. There are 2 spacers utilised per...

Tee-bolt used on the #7, #8 spring jump, and #Econo Shank Assemblies. The tee-bolt runs through the centre of the spring to secure it to the assemb...

Chain tensioner made in engineering plastic, outer diameter 50mm, 80mm long.

M20 U-Bolt to secure to 150x200 RHS.

U-Clamp mounts the shank assembly onto the RHS frame. Suits the 150x150mm (020-1005) #8 Rigid Shank Assembly. Old Part No: 020-205

U-Clamp mounts the shank assembly onto the RHS frame. Suits the 178x178mm (020-1000) #8 Rigid Shank Assembly. Old Part No: 020-206

V bolt secures to 100x100 RHS with M16 hardware.

Part of the 'Shark Tooth' assemblies 111-2020 and 111-2022. This component sets the depth of the #8 shank in the assembly. *Old Part No. 111-324